Start by drilling a through hole at one end of each of four D pieces, which will become the tops of the four side modules. (A 40 mm Forstner bit, about 0.5 mm larger, can also be used.) Use a compass to draw the 1-7/8″-diameter outer perimeter of the top center collar.īefore drilling each hole, deepen the awl mark with a center punch to make it easier to position the Forstner bit accurately. This size easily accommodates a standard tea light candle without excessive play. You’ll use a 1-9/16″-diameter Forstner bit to drill all holes. This, however, will require drilling both through and shallow holes in the modules to obtain the necessary depth for the candles. I chose 3/8″-thick stock for a more delicate look than is typical of most tea light candleholders. Adjust the drill press to the correct speed for the bit size. Then remove the paper patterns and any adhesive residue that remains.ĭrilling the Holes Before drilling the candle holes, stabilize the fragile end of the piece being drilled by butting it against the matching curve of a bottom side piece (E). Trim the sides where indicated from two of the C pieces. Prick all drilling points with an awl, then cut and sand all pieces labeled A through E to shape. Start by downloading and printing out the free PDF patterns, cut them out and attach them to your 3/8″ stock with repositionable spray adhesive. We’ll build the nine-candle menorah shown here. Cutting proud and then sanding the concave or convex contours to the lines is the simplest way to make accurate cuts with smooth edges. While all of these parts can be cut out with a scroll saw, you can expedite the cutting process for the side and end modules by first using a table saw to rip that stock to 1-7/8″ wide. Cut out the parts using a scroll saw or band saw, sawing just outside the layout lines. Additional pieces of 3/8″-thick stock are used for the lower center support and the collar for the center candle. They are then drilled and sanded as needed before being glued together.Įach module consists of two 3/8″-thick pieces: a top piece that is drilled with holes for the candles and a bottom piece that allows the convex and concave ends of adjacent modules to slide into each other. The modules can be arranged and glued to form either straight or curved arms.Ĭutting Components from Patterns All of the components for the nine-light menorah are cut from 3/8”-thick stock. It can be made with nine candles as a menorah or with fewer candles as a table decoration.Īll versions require one center module and two end modules the number of side modules linking the center and end modules can vary as you wish. My “modular” design uses tea light candles for a stylish, modern look. Whether secular or religious, festive candleholders are an integral part of the holiday season.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |